SDMC TMP-3T Manual do Utilizador descarregar pdf (Página 308)

100

101

282 IBM Systems Director Management Console: Introduction and Overview

The output of the Power Systems management commands on the SDMC is the

same as it used to be on the HMC, as shown in Example 10-3.

Example 10-3 SDMC command output

sysadmin@sdmc2:~> smcli lssyscfg -r sys -F name,state

p570_170,Operating

POWER7_1-061AA6P,Operating

p570_6A0,Operating

sysadmin@sdmc2:~> smcli lshwres -r virtualio --rsubtype fc --level sys

-m p570_6A0

num_wwpns_remaining=65496,wwpn_prefix=C0507600096A

For nearly all Power Systems management commands, there is a man page that

can be accessed by running man command name or man psm.command name.

There are two new commands introduced in SDMC:

򐂰 impdata

򐂰 mk5250

You can find a description of them in “IBM Power Systems management

commands” on page 368.

10.2 HMC commands supported on the SDMC

Table 10-3 lists the HMC commands supported in the SDMC along with their

purpose and details about what has changed, if anything, for each command in

the SDMC. For the syntax of these commands, refer to the man pages or go to

the following address:

http://www14.software.ibm.com/webapp/set2/sas/f/hmcl/resources.html

There are some commands that are not listed at the website for the HMC. You

can find these commands in “IBM Power Systems management commands” on

page 368.

Table 10-3 HMC commands supported at the SDMC

HMC command Usage of command Changed

asmmenu Launches the Advanced Systems

Management Interface (ASMI) for a

managed system using the browser on

the SDMC.

This command must be run without the

smcli prefix.

1 2 ... 303 304 305 306 307 308 309 310 311 312 313 ... 435 436

Comentários a estes Manuais

Sem comentários

SDMC TMP-3T Manual do Utilizador Página 308

Comentários a estes Manuais